The FCB‑CV7520 is one of Sony’s popular high‑definition auto‑focus camera modules. Boasting outstanding performance, 1080P@60fps Full HD output and a moderate form factor, it stands out among HD cameras and is widely deployed in security surveillance, UAVs, medical imaging, marine operations, inspection equipment, video conferencing, intelligent transportation, robotics and other industries. When using the FCB‑CV7520, connection to an HDMI encoder control board is sometimes required. What are the connection procedures? Our editor from Kaimorui outlines them below.

Connection Steps for FCB‑CV7520 and HDMI Encoder Control Board

I. Preparation of Materials

1. Sony FCB‑CV7520 camera block
2. HD HDMI encoder control board
3. 16‑pin main communication cable
4. LVDS ribbon cable
5. HDMI cable
6. DC12V power supply and power cord
7. HDMI‑capable monitor or television

II. Connection Procedures

1. Connect the LVDS ribbon cable to the FCB‑CV7520 camera block Insert the LVDS ribbon cable into the LVDS port of the Sony FCB‑CV7520 with its gold contacts facing upward and kept parallel to the connector. Both ends of the ribbon cable must align parallel with the ports, and no gold contacts should remain exposed.
2. Connect the other end of the LVDS ribbon cable to the HDMI encoder board Connect the opposite end of the LVDS ribbon cable to the HDMI encoder control board, following the same method and precautions specified in Step 1.
3. Power up the HDMI encoder board Connect the prepared DC12V 1A power cord to the HDMI encoder control board. Important note: the supply voltage must not exceed 12V, otherwise the control board may be damaged. The current rating should be 1A or higher.
4. Attach the HDMI cable to the encoder board Connect the HDMI cable between the HDMI encoder control board and the monitor. Allow a short waiting period after connection for the signal to appear.
5. Basic operation after wiring Operation is consistent with other encoder control boards. Use the 5‑way navigation button on the board. Press and hold for 5 seconds to bring up the on‑screen menu, then navigate with up/down/left/right/center controls to access the menus of the Sony FCB‑CV7520 and control the camera module via the buttons.

The above covers the connection workflow for the FCB‑CV7520 and HDMI encoder control board. We hope this guide is helpful. For further product information, please contact or follow Kaimorui; our professional team will provide support.